e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
BACKUP FUNCTION
9 - 4
[C] Confirmation of the error
"Backup Failed" or “Restore Failed” is displayed on the lower left part of the LCD screen when the data
have not been properly backed up or restored.
Moreover, details of an error are displayed under the above message.
(The following is an example screen when "USB device not detected" is displayed.)
Fig.12-1
In this case, turn the power OFF and then check the following items. After confirming and solving the
problem, back up / restore the data again from the beginning.
• Does the USB device meet the conditions being used for this cloning?
• Is the updated program file written on the USB device properly?
• Is the USB device installed properly?
• Is the USB device or the equipment damaged?
Backup
Display content Error content
USB device not detected The USB device has not been installed.
SRAM Device Not Connected The SRAM board (for the SYS board) has not been
installed.
Backup not created Creation of the Backup file of data of the SRAM board
(for the SYS board) has been failed.
Encryption Failed An encryption of the backup file has been failed.
password Not Appended to Backup Addition of the encryption password has been failed.
MFP Serial Number Not Set Acquisition of the MFP Serial No. has been failed.
Restore
Display content Error content
USB device not detected The USB device has not been installed.
SRAM Device Not Connected The SRAM board (for the SYS board) has not been
installed.
Invalid Backup File The SYS board has not been recognized.
No Backup File Exists Backup file has not existed in the USB device.
Invalid password An incorrect password has been entered.
Decryption Failed Decoding of the backup file has been failed.
SRAM Data Cloning Mode Firmware Version : x. x. x. x
Select number (1-2) and press START key
Backup Failed
USB device not detected
Update Mode : 59 Mode
2: Restore SRAM Data from USB
To Next Page
Loading...
