Toshiba e-Studio477s - HDD Connection Error; Partition Mount Error; Root Partition Mount Error

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
5 - 48
[F101_0] HDD connection error (HDD connection cannot be detected.)
[F101_1] Root partition mount error (HDD formatting fails.)
[F101_2][F101_3] Partition mount error (The HDD cannot be connected (mounted) caused by
damage to areas other than those described in the F101_1 and F101_4 to F101_10 errors.)
Classification Contents
Other service call HDD unmounted: Connection of HDD cannot be detected.
Sub-code 0: HDD connection error (HDD connection cannot be
detected.)
Sub-code 1: Root partition mount error (HDD formatting fails.)
Sub-code 2, 3: Partition mount error (The areas other than
those described in the F101_1 and F101_4 to F101_10 errors
are damaged.)
Check item Measures
HDD, SYS board, Setting 1. Turn the power of the equipment OFF and check the
connection of the HDD.
- Connector and harness check
- Check if the connector pins of the HDD are bent.
- Check if HDD for other equipment is not installed.
- Check if SRAM for other equipment is not installed.
2. If the error still occurs after step 1, perform the following.
- Perform [3C] - [5] (Key Backup Restore) and check
that each Key Status is "OK".
- If not, recover the key (copy "SRAM Key Status" to
"FROM Key Status" or vice versa).
3. If the error still persists after step 2, perform the
following.
- Perform [3C] - [3] (Format HDD), and then install
"System Software (HD data)" with [49] - [4].
Notes:
The following items will be deleted by performing
[3C] - [3] (Format HDD).
• Message Log
•Job Log
• Spool Data (Print, Email reception)
• Template
If F101_1 occurs with ADI-HDD or the error persists
after performing step 3, perform step 3 after
performing [4]+[C]+[POWER]1. Revert factory
initial status HDD.
4. If the error persists even after step 3, replace the HDD.
Replacement part Measure
HDD
SYS board