Toshiba e-Studio477s - Connecting the Cables; Connecting the Network Cables; Connecting the USB Cable

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
3 - 20
• When a normal HDD is mounted
Fig. 3-8
Remarks:
• If the HDD type cannot be identified, "Unknown HDD" may appear on the screen.
Refer to  P. 5-56 " [F106_1] ADI-HDD error: HDD type detection error"
Notes:
• When "SATA HDD" (normal HDD) is displayed, items 1 and 2 are not selectable.
• If you select any of 1 and 2 and press the [START] button, the error message below appears.
Fig. 3-9
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
HDD Assist Mode
Current HDD type: SATA HDD
Select number (1-2) and press START key
1. Revert factory initial status HDD
2. Remove key
System Firmware Version
Update Mode
: xxxx(x.x.x.x)
: 4c Mode
=>
Operation Failed.
Press SoftPower Key to Switch Off