Toshiba e-Studio477s - Functions; Revert Factory Initial Status HDD

To Next Page

To Previous Page

SELF-DIAGNOSTIC MODE

3 - 21

3.10.3 Functions

[A] 1. Revert factory initial status HDD

Select this to dispose of the ADI-HDD as well as the equipment.

When this item is selected, all data in the HDD are deleted and the HDD is reverted to its initial status at

the factory shipment.

This operation requires only a few seconds; however, you must create the partition in the HDD in the

3C mode (Format HDD) and reinstall the HDD data in the 49 mode to make the HDD reusable.

When "1" is selected and then [START] button is pressed, the menu below appears.

To start, press the [START] button.

Fig. 3-10

When the operation is finished, the result appears on the menu.

Fig. 3-11

Notes:

If the equipment is started in the normal mode with this condition, an HDD mounting error occurs.

HDD Assist Mode

Current HDD type: ADI HDD

Select number (1-2) and press START key

1. Revert factory initial status HDD

2. Remove key

System Firmware Version

Update Mode

: xxxx(x.x.x.x)

: 4c Mode

Confirmation Screen

Are you sure ???

Press START to continue

Press STOP to cancel