e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
5 - 92
[6033] Card related error: Invalid flag data (no room-entry data)
[6034] Card related error: Invalid flag data (invalid card data)
[6041] Card authentication: Card related error
[6042] Card authentication: Card setting error
[6121] Automatic Secure Erase failure
Check item Measures
Setting Use a card with a valid expiration.
Classification Error item
MFP access error The card cannot be used because no room-entry data are
recorded in it.
Check item Measures
Setting Use a correct card that has been used for entering the room.
Classification Error item
MFP access error The card cannot be used because the data required for the
use of the card are not correctly set.
Check item Measures
Setting Use a valid card.
Classification Error item
MFP access error Card data cannot be obtained correctly.
Check item Measures
Setting Reattempt scanning. If the error still occurs after reattempting
scanning for several times, card data may be corrupted or the
card reader may be out of order.
Classification Error item
MFP access error The self-diagnostic code required for card authentication is
not set in this equipment correctly.
Check item Measures
Setting Set the correct self-diagnostic code.
Classification Error item
MFP access error The automatic secure erase fails.
Check item Measures
Setting Data overwriting failed for some reason. If the error still
occurs after rebooting the equipment, start up using the
following procedure:[3] + [C] + [POWER] 3. HDD
formatting Reinstallation of software or HDD replacement
To Next Page
Loading...
