Toshiba e-Studio477s - External Counters; Pin Layout; Signal

10
© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
EXTERNAL COUNTERS
10 - 1
10. EXTERNAL COUNTERS
10.1 Outline
This chapter describes the interface between the equipment and coin controller. This equipment does
not support card controller and mechanical counter.
10.2 Signal
Notes:
•
Use 24V supplied from the main equipment as power for the output signals (KCTRON) from the
transistor.
• Do not connect inductive loads, such as a mechanical counter or a relay coil, to CTRON.
10.2.1 Pin Layout
1. Connector on the PU board: COIN (JST-made B20B-CZHK-B-1(LF)(SN)(V)) (Coin Controller)
Pin
No.
I/O Signal name Function Voltage level Remarks
GQ-
1260
1GND
SG Signal Ground 0V
-
2In
CTRCNT Copy permission
Signal 1
L=0V, H=DC3.3V
-
3 Power
+24V 24V line DC24V+10%, -5%
-
4Out
KCTRON Mechanical
Counter On Signal
Open Collector L: ON
-
5 Power
+24V 24V line DC24V+10%, -5%
-
6Out
CTRON Total Counter On
Signal
Open Collector L: ON
In use
7In
CTRCNT Copy permission
Signal 1
L=0V, H=DC3.3V L: Allowed
In use
8Out
MCRUN Ready to Copy
Signal
Open Collector L: Operating
In use
9Out
EXTCTR Exit Sensor On
Signal
Open Collector L: Operating
In use
10 GND
PG Power ground 0V
In use
11 Out
BKCTR Black mode
Counter Signal
Open Collector L: Operating
-
12 Out
MNCTR Mono color mode
Counter Signal
Open Collector L: Operating
-
13 Out
FLCTR Full color mode
Counter On Signal
Open Collector L: Operating
-
14 GND
SG Signal Ground 0V
-
15 Out
SIZE3 Paper size Signal
3
Open Collector L: Operating
-
16 Out
SIZE2 Paper size Signal
2
Open Collector L: Operating
-
17 Out
SIZE1 Paper size Signal
1
Open Collector L: Operating
-
18 Out
SIZE0 Paper size Signal
0
Open Collector L: Operating
-
19 Power
+5V (Sleep) 5V line DC5.1V At the sleep mode:OFF
In use
20 -
N.C. - -
-