Toshiba e-Studio477s - Confirmation of the Updated Data; Display During the Update

To Next Page

To Previous Page

FIRMWARE UPDATING

8 - 15

(9) Press the [ON/OFF] button to shut down the equipment, and then remove the USB device.

(10) Perform the initialization of the updating data.

• Press the [ON/OFF] button while holding down the [0] and [8] buttons simultaneously.

• Key in “9030”, and then press the [START] button.

• Press [INITIALIZE].

Notes:

This step is unnecessary for a patch update.

[B] Confirmation of the updated data

After the updating is completed, check each data version in the Setting Mode (08) to confirm that the

data were overwritten properly.

 P. 8-26 "8.5 Confirmation of the updated data"

[C] Adjustment

Perform the adjustment of the equipment.

• Automatic gamma adjustment (05-7165) (using [10][FAX] test pattern):

 P. 4-4 "4.2.1 Automatic gamma adjustment"

[D] Display during the update

Update is performed in parallel as shown in the transition diagram below.

Update Completed

1. SYSTEM

FIRMWARE

(OS Data)

2. ENGINE

FIRMWARE

3.SCANNER

FIRMWARE

4. SYSTEM

SOFTWARE

(HD Data)

Item Selection Screen for Update

[

System firmware

]

[Engine firmware][Engine firmware]

[Scanner firmware]

[System software]

Other manuals for Toshiba e-Studio477s