Toshiba e-Studio477s - ADI-HDD Error: ADI Encryption Key Download Operation Error; ADI-HDD Error: HDD Type Detection Error

e-STUDIO477S/527S/477SL © 2013-2016 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
5 - 56
[F106_1] ADI-HDD error: HDD type detection error
[F106_2] ADI-HDD error: ADI encryption key download operation error
HDD • Connector check
• Harness check
Follow the procedure below if no abnormality is found in the
check items above.
1. Start the equipment in the 4C mode: [4] + [C] +
[POWER] -> 1. Revert factory initial status HDD
2. Reinstall the system software.
If the error persists even after above step, replace the HDD.
If the equipment operation disabled after above step,
replace the HDD.
Classification Error item
Other service call
ADI-HDD error: HDD type detection fails.
Check item Measures
Setting If the error is not recovered after rebooting the equipment
or no abnormality is found on any check items for the HDD,
reinstall the system software.
HDD • Connector check
• Harness check
• Start the equipment in the 5C mode: [5] + [C] +
[POWER]
Check the file system and recover it if necessary.
If the recovery fails, replace the HDD.
If the equipment does not start in the 5C mode, also
replace the HDD.
• Check that either the ADI-HDD or SATA-HDD (normal
type) is mounted.
1. Start the equipment in the 4C mode: [4] + [C] +
[POWER]
2. Check the type of the HDD shown on the top left of the
control panel display "Current HDD type".
Normal status: ADI-HDD or SATA-HDD
Abnormal status: Unknown HDD
If "Unknown HDD" is displayed, reinstall the system
software.
If the error persists even after above step, replace the HDD.
If the equipment operation disabled after above step,
replace the HDD.
Classification Error item
Other service call
ADI-HDD error: Downloading of or consistency check for ADI-
HDD encryption key fails.
Check item Measures