© 2013-2016 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO477S/527S/477SL
REPLACEMENT OF PC BOARDS/HDD
6 - 3
6
(6) Release the latches (I) and (II).
As shown in the figure, insert a flathead
screwdriver into the groove and push it in the
direction of the arrow to release the latches.
Notes:
When using tools, be sure not to put your
face and hands in the direction in which force
will be applied; otherwise this could result in
injury. In addition, be sure not to damage the
cover.
Fig.6-8
Fig.6-9
(7) Pull the bottom of the cover outward, release
the latch, and remove the cover.
Fig.6-10
I
II
To Next Page
Loading...
