2Troubleshooting Procedures
Satellite A660/A665 Series Maintenance Manual
components may be damaged. To determine if the computer’s HDD/SDD is functioning
properly, perform the following procedures. Figure 2-16 outlines the process. Start with
Procedure 1 and continue with the other procedures as instructed.
Procedure 1: Diagnostic test
Procedure 2: Connector and replacement check
Procedure 1 Diagnostic test
Run the Diagnostic Program, which will automatically execute the HDD/SSD R/W test.
(Refer to Chapter 3 system configuration check), Tests and Diagnostics for more information
on the program.
If an error is located, go to Procedure 2. If an error is not located, the HDD/SSD function is
functioning properly.
Procedure 2 Connector and replacement check
The HDD module or system board may be disconnected or damaged. Disassemble the
computer following the steps described in Chapter 4, Replacement Procedures, and perform
the following checks.
Check 1 Make sure that the HDD module is securely slotted into the system board. If the
problem persists, go to Check 2.
Check 2 The HDD module may be damaged. Replace it with a new one following the
instructions in Chapter 4. If the problem still exists, perform Check 3.
Check 3 The system board may be damaged. Replace it with a new one following the
instructions in Chapter 4.
To Next Page
Loading...
Need help?
General
