OPERATOR’S MANUAL
series Robot Controller
(b) Step 2: Input through EXE key.
Make sure that your entry is correct, and press the EXE key. Unless label
RCYCLE exists in the main program, the execution conditions, etc., remain
unchanged.
M O D E : T E A C H I N G / C O N T T E S T P R O
L : 28
O : 20%
M : F REE
S : S TOP
C O NT
M O D E O V R D R E S E T D O W A T C H >
(3) Cautions
• Use label RCYCLE in a desired step of the main program.
• Also, specify the GOTO RCYCLE command just before the END command
not to execute the END command of the main program.
STE 80720
– 6-27 –
To Next Page
Loading...
