OPERATOR’S MANUAL
series Robot Controller
(c) Step 3: Input of EXE key.
Make sure that your entry is correct, and press the EXE key. Then the
specified file name is displayed in the execution file display field on the 1st
line.
M O D E : I N T E R N A L
C O N T T E S T P R O
L :
O : 1 00%
M : F REE
S : S TOP
R E SET
S E L M O D E O V R D R E S E T >
(3) Cautions
• Once the execution file has been selected, it remains effective until another
file is selected. If a compile error has occurred, however, selection of the
execution file is canceled.
• When another file has been selected, the execution environment of automatic
operation is reset. To reset the execution environment without changing the
execution file, execute [RESET] and [PROG].
STE 80720
– 7-5 –
To Next Page
Loading...
