OPERATOR’S MANUAL
series Robot Controller
(b) Step 2: Input through EXE key.
Make sure that your entry is correct, and press the EXE key. "STOP
(RESET)" is shown under "S" (execution status) on the teach pendant display.
M O D E : I N T E R N A L
C O N T T E S T P R O
L :
O : 1 00%
M : F REE
S : S TOP
R E SET
S E L M O D E O V R D R E S E T >
(3) Cautions
• All variables used in the program are reset.
• If you do not wish to the variables, use the step reset function instead.
STE 80720
– 7-18 –
To Next Page
Loading...
