OPERATOR’S MANUAL
series Robot Controller
7.7.2 Step Reset
(1) Function
Resets all execution conditions (excluding global variables) for a current file and
allows execution of that program from the top.
(2) Procedures
(a) Step 1: Command selection.
Press the NEXT key repeatedly until [RESET] is displayed in the menu, and
press the corresponding function key.
M O D E : I N T E R N A L / C O N T T E S T P R O
L : 28
O : 1 00%
M : F REE
S : S TOP
C O NT
S E L M O D E O V R D R E S E T >
Select [STEP] by pressing the corresponding function key.
M O D E : I N T E R N A L / C O N T T E S T P R O
L : 28
O : 1 00%
M : F REE
S : S TOP
C O NT
R E S E T : S T E P
P R O G C Y C L E S T E P S I G S E L
STE 80720
– 7-19 –
To Next Page
Loading...
