OPERATOR’S MANUAL
series Robot Controller
After selecting the file name after change, press the EXE key. When you
wish to create a new file, press [INPUT] and enter the file name. The
selected file name can also be changed like the file name before change. If
you press the ESC key, you can delete a file name. If you further press the
same key, the system returns to the "input of file name before change" mode.
: A B C D
Make sure that the input file name is correct, then press the EXE key.
(e) Step 5: Input through EXE key.
When the confirmation message appears, make sure of the input file name
again. Then press the EXE key.
R e n a m e R : A B C - > R : A B C D ?
O K T H E N < E X E >
(f) Step 6: Input through ANY key.
When the file has been renamed, the following message appears.
When you press any key on the teach pendant, the system returns to Step 2
and you can continue renaming.
R e n a m e R : A B C - > R : A B C D ?
C o m p l e t e d .
H I T A N Y K E Y
If the specified file name before change already exists, the system waits for
your answer, displaying a message saying "Already exist. Delete?".
C o p y R : A B C - > R : A B C D ?
l r e a d y e x i s t . D e l e t e ?
O K T H E N < E X E >
STE 80720
– 9-10 –
To Next Page
Loading...
