STE 80720
– 10-3 –
OPERATOR’S MANUAL
series Robot Controller
Menu Descriptions
[ENC] Used to display the servo encoder data.
Note: This function is intended for the maintenance.
Operate this key according to the instructions of our
service engineers.
[PLC–M] Used to display the PLC data.
[MEMOR]
Used to display the system internal memory.
Note: This function is intended for the maintenance.
Operate this key according to the instructions of our
service engineers.
[ZEROP] Used to set the origin (or home point).
Note: This function is intended for the maintenance.
Operate this key according to the instructions of our
service engineers.
[VER] Used to display the system version.
[CONV] Used to display each status of the conveyor synchronization
function.
Note: For details, see the Conveyor Synchronous Function
Instruction Manual provided separately.
[ETHER] Used to display the Ethernet status.
Note: For details, see the Communication Manual provided
separately.
ETHER function is provided as standard in TS3000
and as an option in TSL3000.
[PAYLD] Used to display PAYLOAD set values for manual operation
and set a PAYLOAD value as necessary.
[FCTRY] Note: This is a function for initialization at shipment. Users
must not use.
[BCKUP] Used to display backup operation to the flash memory.
(3) Caution
This function can be used in the teaching, internal automatic and external
automatic modes.
To Next Page
Loading...
