STE 80720
– 10-39 –
OPERATOR’S MANUAL
series Robot Controller
Keys operative in this mode and their operations are shown below.
Key Descriptions
↑
Used to move the main cursor up. The command line is
cleared.
↓
Used to move the main cursor down. The command line is
cleared.
←
Used to move the main cursor to the left. The command line
is cleared.
→
Used to move the main cursor to the right. The command
line is cleared.
Numeral
Used to input characters on the command line.
EXE
Used to change the data indicated by the main cursor to the
input value.
BS
Used to delete one (1) character just before the main cursor
position on the command line.
ALT +BS
Used to delete one (1) character at the main cursor position on
the command line.
ESC
Used to return the system to the utility display.
(b) Step 2: Data input.
Move the main cursor to a data you wish to change, and enter a new data.
Character input to the command line is always effective.
D A T E U T I L I T Y
D A T E S e p - 01- 2008
T I M E 1 2 : 0 0
M O N T H ? [ 1 - 1 2 ] > 9
To Next Page
Loading...
