Toshiba TS3000 Series - Page 61

OPERATOR’S MANUAL
series Robot Controller
(c) Step 3: File selection.
Select the file name by means of the up and down cursor keys.
To create a new file, press [NEW].
E D I T ( 0 0 1 / 2 5 6 )
*
A
B C D 1 2 3 4 . 5 6 7 1 2 3 4 5 6 F e b - 1 2 - 2 0 0 8
F I L E 0 0 0 2 . 0 1 2 1 2 3 4 5 6 F e b - 1 3 - 2 0 0 8
F I L E 0 0 0 3 . 0 1 2 1 2 3 4 5 6 F e b - 1 4 - 2 0 0 8
F I L E 0 0 0 4 . 0 1 2 1 2 3 4 5 6 F e b - 1 5 - 2 0 0 8
F I L E 0 0 0 5 . 0 1 2 1 2 3 4 5 6 F e b - 1 6 - 2 0 0 8
:
_
N A M E T I M E N E W
Unless the F3 [NEW] key was pressed:
Press the EXE key, and the selected file name is displayed on the command
line. It is also possible to rename the file. For this purpose, return the
cursor by means of the BS key and enter a desired file name.
E D I T ( 0 0 1 / 2 5 6 )
* A B C D 1 2 3 4 . 5 6 7 1 2 3 4 5 6 F e b - 1 2 - 2 0 0 8
F I L E 0 0 0 2 . 0 1 2 1 2 3 4 5 6 F e b - 1 3 - 2 0 0 8
F I L E 0 0 0 3 . 0 1 2 1 2 3 4 5 6 F e b - 1 4 - 2 0 0 8
F I L E 0 0 0 4 . 0 1 2 1 2 3 4 5 6 F e b - 1 5 - 2 0 0 8
F I L E 0 0 0 5 . 0 1 2 1 2 3 4 5 6 F e b - 1 6 - 2 0 0 8
: F I L E 0 0 0 2 . 0 1 2
N A M E T I M E N E W
STE 80720
– 4-2 –