TP-Link TL-SL5428E - Page 119

 Eqphkiwtcvkqp"Rtqegfwtg" "
 Configure switch A:
Uvgr" Qrgtcvkqp" Fguetkrvkqp"
1 Configure ports On XNCP→:2403S"XNCP page, configure the link type
of the related ports as Trunk, and add the ports to
VLAN101-VLAN106. The detailed instructions can be
found in the section 802.1Q VLAN
.
2 Enable STP function On Urcppkpi" Vtgg→UVR"Eqphki→UVR"Eqphki page,
enable STP function and select MSTP version.
On Urcppkpi" Vtgg→UVR"Eqphki→Rqtv"Eqphki page,
enable MSTP function for the port.
3 Configure the region name and
the revision of MST region
On Urcppkpi"Vtgg→OUVR"Kpuvcpeg→Tgikqp"Eqphki
page, configure the region as TP-LINK and keep the
default revision setting.
4 Configure VLAN-to-Instance
mapping table of the MST region
On Urcppkpi" Vtgg→OUVR" Kpuvcpeg→Kpuvcpeg"
Eqphki page, configure VLAN-to-Instance mapping
table. Map VLAN 101, 103 and 105 to Instance 1; map
VLAN 102, 104 and 106 to Instance 2.
 Configure switch B:
Uvgr" Qrgtcvkqp" Fguetkrvkqp"
1 Configure ports On XNCP→:2403S"XNCP page, configure the link type
of the related ports as Trunk, and add the ports to
VLAN101-VLAN106. The detailed instructions can be
found in the section 802.1Q VLAN
.
2 Enable STP function On Urcppkpi" Vtgg→UVR"Eqphki→UVR"Eqphki page,
enable STP function and select MSTP version.
On Urcppkpi" Vtgg→UVR"Eqphki→Rqtv"Eqphki page,
enable MSTP function for the port.
3 Configure the region name and
the revision of MST region
On Urcppkpi"Vtgg→OUVR"Kpuvcpeg→Tgikqp"Eqphki
page, configure the region as TP-LINK and keep the
default revision setting.
4 Configure VLAN-to-Instance
mapping table of the MST region
On Urcppkpi" Vtgg→OUVR" Kpuvcpeg→Kpuvcpeg"
Eqphki page, configure VLAN-to-Instance mapping
table. Map VLAN 101, 103 and 105 to Instance 1; map
VLAN 102, 104 and 106 to Instance 2.
5 Configure switch B as the root
bridge of Instance 1
On Urcppkpi" Vtgg→OUVR" Kpuvcpeg→Kpuvcpeg"
Eqphki page, configure the priority of Instance 1 to be 0.
6 Configure switch B as the
designated bridge of Instance 2
On Urcppkpi" Vtgg→OUVR" Kpuvcpeg→Kpuvcpeg"
Eqphki page, configure the priority of Instance 2 to be
4096.
107