360505" Cncto"Eqphki"
On this page, you can configure Statistic Group and Alarm Group for RMON.
Choose the menu UPOR→TOQP→Cncto"Eqphki to load the following page.
Figure 14-12 Alarm Config
The following entries are displayed on this screen:
" Cncto"Vcdng"
Ugngev<"
Select the desired entry for configuration.
Kpfgz<"
Displays the index number of the entry.
Xctkcdng<"
Select the alarm variables from the pull-down list.
Rqtv<"
Select the port on which the Alarm entry acts.
Ucorng"V{rg<"
Specify the sampling method for the selected variable and
comparing the value against the thresholds.
Cduqnwvg< Compares the values directly with the thresholds
at the end of the sampling interval.
Fgnvc< Subtracts the last sampled value from the current
value. The difference in the values is compared to the
threshold.
Tkukpi"Vjtgujqnf<"
Enter the rising counter value that triggers the Rising Threshold
alarm.
Tkukpi"Gxgpv<"
Select the index of the corresponding event which will be
triggered if the sampled value is larger than the Rising
Threshold.
Hcnnkpi"Vjtgujqnf<"
Enter the falling counter value that triggers the Falling Threshold
alarm.
Hcnnkpi"Gxgpv<"
Select the index of the corresponding event which will be
triggered if the sampled value is lower than the Falling
Threshold.
250
To Next Page
Loading...
