" Rqtv"Eqphki"
Ugngev<"
Select the desired port for NTDP status configuration.
Rqtv<"
Displays the port number of the switch.
PVFR<"
Displays NTDP status (enabled or disabled) of the current port.
Gpcdng<"
Click the Gpcdng"button to enable NTDP feature for the port you
select.
Fkucdng<"
Click the Fkucdng"button to disable NTDP feature for the port you
select.
Pqvg<"
NTDP function is effective only when NTDP function is enabled globally and for the port.
3805"Enwuvgt"
A commander switch can recognize and add the candidate switch to a cluster automatically based
on NDP and NTDP. You can manually add the candidate switch to a cluster. If the candidate switch
is successfully added to the cluster, it will get a private IP address assigned by the commander
switch. You can manage and configure the member switch via the commander switch.
The Cluster function can be implemented on Enwuvgt"Uwooct{,"Enwuvgt"Eqphki,"Ogodgt"Eqphki"
and"Enwuvgt"Vqrqnqi{"pages.
380503" Enwuvgt"Uwooct{"
On this page you can view the status of the current cluster.
Choose the menu"Enwuvgt→Enwuvgt→Enwuvgt"Uwooct{"to load the following page.
For a candidate switch, the following page is displayed:
Figure 16-9 Cluster Summary for Candidate Switch
The following entries are displayed on this screen:
" Inqdcn"Eqphki"
Enwuvgt<"
Displays the cluster status (enabled or disabled) of the switch.
Enwuvgt"Tqng<"
Displays the role the switch plays in the cluster.
271
To Next Page
Loading...
