Figure 10-7 Port Config
The following entries are displayed on this screen:
" Rqtv"Eqphki"
Rqtv"Ugngev<"
Click the Ugngev button to quick-select the corresponding port
based on the port number you entered.
Ugngev<"
Select the desired port for IGMP Snooping feature configuration. It
is multi-optional.
Rqtv<"
Displays the port of the switch.
KIOR"Upqqrkpi<"
Enable/Disable IGMP Snooping for the desired port.
Hcuv"Ngcxg<"
Enable/Disable Fast Leave feature for the desired port. If Fast
Leave is enabled for a port, the switch will immediately remove
this port from the multicast group upon receiving IGMP leave
messages.
Hknvgt<"
Enable/Disable multicast filtering feature on the port.
Cevkqp"Oqfg<"
Select the action mode to process multicast packets when the
multicast IP is in the filtering IP-range.
Permit: Only the multicast packets whose multicast IP is in the
IP-range will be processed.
Deny: Only the multicast packets whose multicast IP is not in
the IP-range will be processed.
Dqwpf"KR/Tcpig"
*KF+<"
Enter the IP-range ID the port will be bound to. The binding
IP-range IDs of the port can be cleared by entering null value in
this field and click Crrn{ button to submit the configuration.
Ocz"Itqwru<"
Specify the maximum number of multicast groups to prevent some
ports taking up too much bandwidth.
NCI<"
Displays the LAG number which the port belongs to.
144
To Next Page
Loading...
