" Gpvt{"Fguetkrvkqp<"
Ugtxgt"KR<"
Enter the IP of the server running the RADIUS secure protocol.
Ujctgf"Mg{<"
Enter the shared key between the RADIUS server and the switch.
The RADIUS server and the switch use the key string to encrypt
passwords and exchange responses.
Cwvj"Rqtv<"
Specify the UDP destination port on the RADIUS server for
authentication requests.
Ceev"Rqtv<"
Specify the UDP destination port on the RADIUS server for
accounting requests.
Tgvtcpuokv<"
Specify the number of times a request is resent to a server if the
server does not respond.
Vkogqwv<"
Specify the time interval that the switch waits for the server to reply
before resending.
350906" VCECEU-"Ugtxgt"Eqphki"
This page is used to configure the authentication servers running the TACACS+ security protocols.
Choose the menu Pgvyqtm"Ugewtkv{→CCC→VCECEU-"Eqpkhi to load the following page.
Figure 13-4 TACACS+ Server Config
" Eqphkiwtcvkqp"Rtqegfwtg<"
Configure the TACACS+ server’s IP and other relevant parameters under the Server Config.
View, edit and delete the configured TACACS+ servers in the Server list.
" Gpvt{"Fguetkrvkqp<"
Ugtxgt"KR<"
Enter the IP of the server running the TACACS+ secure protocol.
Ujctgf"Mg{<"
Enter the shared key between the TACACS+ server and the switch.
The TACACS+ server and the switch use the key string to encrypt
passwords and exchange responses.
Vkogqwv<"
Specify the time interval that the switch waits for the server to reply
before resending.
Rqtv<"
Specify the TCP port used on the TACACS+ server for AAA.
226
To Next Page
Loading...
