370303" Inqdcn"Eqphki"
On this page you can configure the LLDP parameters of the device globally.
Choose the menu"NNFR→Dcuke"Eqphki→Inqdcn"Eqphki to load the following page."
Figure 15-1 Global Configuration
The following entries are displayed on this screen:
" Inqdcn"Eqphki"
NNFR<"
Enable/disable LLDP function globally.
" Rctcogvgtu"Eqphki"
Vtcpuokv"Kpvgtxcn<"
Enter the interval for the local device to transmit LLDPDU to its
neighbors. The default value is 30 seconds.
Jqnf"Ownvkrnkgt<"
Enter a multiplier on the Transmit Interval. It determines the actual
TTL (Time To Live) value used in an LLDPDU. TTL = Hold
Multiplier * Transmit Interval. The default value is 4.
Vtcpuokv"Fgnc{<"
Enter a value from 1 to 8192 in seconds to specify the time for the
local device to transmit LLDPDU to its neighbors after changes
occur so as to prevent LLDPDU being sent frequently. The default
value is 2 seconds.
Tgkpkv"Fgnc{<"
This parameter indicates the amount of delay from when LLDP
status becomes "disable" until re-initialization will be attempted.
The default value is 3 seconds.
Pqvkhkecvkqp"Kpvgtxcn<"
Specify the interval of Trap message which will be sent from local
device to network management system. The default value is 5
seconds.
Hcuv"Uvctv"Eqwpv<"
When the port's LLDP state transforms from Disable (or Rx_Only)
to Tx&Rx (or Tx_Only), the fast start mechanism will be enabled,
that is, the transmit interval will be shorten to a second, and
several LLDPDUs will be sent out (the number of LLDPDUs
equals this parameter). The default value is 3.
256
To Next Page
Loading...
