380405" PVFR"Eqphki"
On this page you can configure NTDP globally.
Choose the menu Enwuvgt→PVFR→PVFR"Eqphki"to load the following page.
Figure 16-8 NTDP Config
The following entries are displayed on this screen:
" Inqdcn"Eqphki"
PVFR<" "
Enable/Disable NTDP for the switch globally.
PVFR"Kpvgtxcn"Vkog<"
Enter the interval to collect topology information. The default is 1
minute.
PVFR"Jqru<"
Enter the hop count the switch topology collects. The default is 3
hops.
PVFR"Jqr"Fgnc{<"
Enter the time between the switch receiving NTDP request
packets and the switch forwarding NTDP request packets for the
first time. The default is 200 milliseconds.
PVFR"Rqtv"Fgnc{<"
Enter the time between the port forwarding NTDP request packets
and its adjacent port forwarding NTDP request packets over. The
default is 20 milliseconds.
270
To Next Page
Loading...
