Figure 10-18 Static Multicast"
The following entries are displayed on this screen:
" Uvcvke"Ownvkecuv"Eqphki"
XNCP"KF<"
Enter the VLAN ID.
Ownvkecuv"KR<"
Enter the multicast IP address.
Ogodgt"Rqtvu<"
Enter the member ports of the static multicast group.
" Uvcvke"Ownvkecuv"Nkuv"
Ugngev<"
Select the static multicast group you want to change.
XNCP"KF<"
Displays the VLAN ID.
Ownvkecuv"KR<"
Displays the multicast group IP address.
Ogodgt"Rqtvu<"
Displays the member ports of the static multicast
group.
320408" Swgtkgt"Eqphki"
In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send out MLD queries and manage the multicast table. But MLD is not supported by the devices in
Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can help
to create and maintain multicast forwarding table on the switch with the Query messages it
generates.
Choose the menu Ownvkecuv→ONF"Upqqrkpi→Swgtkgt"Eqphki to load the following page.
Figure 10-19 Querier Config
160
To Next Page
Loading...
