VNX" Fguetkrvkqp"
U{uvgo"Pcog"VNX
The System Name TLV allows network management to advertise
the system's assigned name, which should be the system's fully
qualified domain name.
Ocpcigogpv" Cfftguu"
VNX
The Management Address TLV identifies an address associated
with the local LLDP agent that may be used to reach higher
entities to assist discovery by network management.
Rqtv"XNCP"KF"VNX
The Port VLAN ID TLV allows a VLAN bridge port to advertise the
port's VLAN identifier (PVID) that will be associated with untagged
or priority tagged frames.
Rqtv"Cpf"Rtqvqeqn"XNCP"
KF"VNX
The Port And Protocol VLAN ID TLV allows a bridge port to
advertise a port and protocol VLAN ID.
XNCP"Pcog"VNX
The VLAN Name TLV allows an IEEE 802.1Q-compatible IEEE
802 LAN station to advertise the assigned name of any VLAN with
which it is configured.
Nkpm"Ciitgicvkqp"VNX
The Link Aggregation TLV indicates whether the link is capable of
being aggregated, whether the link is currently in an aggregation,
and if in an aggregation, the port identification of the aggregation.
OCE1RJ["Eqphkiwtcvkqp1"
Uvcvwu"VNX
The MAC/PHY Configuration/Status TLV identifies: a)The duplex
and bit-rate capability of the sending IEEE 802.3 LAN node that is
connected to the physical medium; b)The current duplex and
bit-rate settings of the sending IEEE 802.3 LAN node; c)Whether
these settings are the result of auto-negotiation during link
initiation or of manual set override action.
Ocz"Htcog"Uk|g"VNX
The Maximum Frame Size TLV indicates the maximum frame
size capability of the implemented MAC and PHY.
Rqygt"Xkc"OFK"VNX
The Power Via MDI TLV allows network management to advertise
and discover the MDI power support capabilities of the sending
IEEE 802.3 LAN station.
The LLDP module is mainly for LLDP function configuration of the switch, including three
submenus:"Dcuke"Eqphki, Fgxkeg"Kphq and Fgxkeg"Uvcvkuvkeu.
3703"Dcuke"Eqphki"
LLDP is configured on the"Inqdcn"Eqphki and Rqtv"Eqphki"pages.
255
To Next Page
Loading...
