4）
Configure the parameters of the FTP server which keeps the upgrade firmware. Later you
can download the firmware to the switch from the FTP server. The format of the command
is: hvr"jquv"xxx.xxx.xxx.xxx"wugt"xxxxx"ryf"xxxxx"hkng"xxxxxx.bin.
Here take the following parameters of the FTP server as an example. IP address is
10.10.70.146; the user name and password for login to the FTP server are both 123; the
name of the upgrade firmware is tl_sl5428e_up.bin. The detailed command is shown as
the following figure. Enter the command and press Gpvgt.
]VR/NKPM_<"hvr"jquv 10.10.70.146 wugt"123"ryf"123"hkng tl_sl5428e_up.bin
5） Enter the upgrade command and press Gpvgt to upgrade the firmware. After a while, the
prompt “You can only use the port 1 to upgrade” will display in the hyper terminal shown
as the following figure.
]VR/NKPM_<"writcfg"
[qw"ecp"qpn{"wug"vjg"rqtv"3"vq"writcfg0"
6） When the prompt “Are you sure to upgrade the firmware[Y/N]:” displays, please enter [ to
start upgrade or enter P to quit upgrade shown as the following figure. The # icon
indicates it is upgrading. After upgrading, the [TP-LINK] command will display.
Ctg"{qw"uwtg"vq"writcfg"vjg"hktoyctg][1P_<"{"
###############################################
###############################################
###############################################
###################################
]VR/NKPM_<"
7） Please enter start command to start the switch shown as the following figure. Then you
can login to the CLI command window and manage the switch via CLI command.
]VR/NKPM_<"uvctv"
Uvctv"0"0"0"0"0"0"0"0"
◀"
"
,",",",",",",",",",",",",",",",","," "
Wugt"Ceeguu"Nqikp
" " ,",",",",",",",",",",",",",",",","
Wugt<" "
When you forget the login user name and password, you can enter reset command after entering
into bootUtil menu to reset the system. The system will be restored to the factory default settings,
and the default login user name and password are both admin.
Return to CONTENTS
290
To Next Page
Loading...
