Basic safety instructions
TR-Electronic GmbH 2009, All Rights Reserved Printed in the Federal Republic of Germany
Page 74 of 108 TR - ECE - BA - DGB - 0070 - 17 12/13/2018
2.9 Organizational measures
● The User Manual must always be kept ready-to-hand at the place of use of the
measuring system.
● In addition to the User Manual, generally valid legal and other binding regulations
on accident prevention and environmental protection must be observed and
communicated.
● The respective applicable national, local and system-specific provisions and
requirements must be observed and communicated.
● The operator is obliged to inform personnel on special operating features and
requirements.
● Prior to commencing work, personnel working with the measuring system must
have read and understood the chapter "Basic safety instructions".
● The nameplate and any prohibition or instruction symbols applied on the
measuring system must always be maintained in a legible state.
● Do not undertake any mechanical or electrical modifications to the measuring
system, except for those expressly described in this User Manual.
● Repairs may only be undertaken by the manufacturer or a center or person
authorized by the manufacturer.
2.10 Personnel selection and qualification; basic obligations
● All work on the measuring system must only be carried out by qualified personnel.
Qualified personnel includes persons, who, through their training, experience and
instruction, as well as their knowledge of the relevant standards, provisions,
accident prevention regulations and operating conditions, have been authorized
by the persons responsible for the system to carry out the required work and are
able to recognize and avoid potential hazards. They are capable of identifying and
avoiding potential hazards.
● The definition of “qualified personnel” also includes an understanding of the
standards VDE 0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-
Verlag GmbH).
● The responsibility for assembly, installation, commissioning and operation must be
clearly defined. The obligation exists to provide supervision for trainee personnel.
To Next Page
Loading...
