Trace Engineering PS Series User Manual

INDEX
Copyright  Trace Engineering Company, Inc.
5916 - 195th Street N.E.
Arlington, WA 98223
Telephone: 360/435-8826
Fax: 360/435-2229
www.traceengineering.com
PS Series Inverter/Charger
Part No. 3597
Rev. D: November 23, 1999
Page
139
Set Load Start Amps AC, Menu (12)..................................48
Set Load Start Delay Min, Menu (12)..................................48
Set Load Stop Delay Min, Menu (12)..................................48
Set Low Battery Cut In VDC, Menu ( 9)..............................46
Set Low Battery Cut Out VDC.............................................49
Set Low Battery Cut Out VDC, Menu ( 9) ...........................46
Set Max Charge Amps .................................................62, 65
Set Max Charge Amps AC, Menu (10) ...............................47
Set Max Cranking Seconds, Menu (13)..............................50
Set Max Sell Amps AC, Menu (17).....................................52
Set Maximum Run Time, Menu (12)...................................49
Set Points Buttons ..............................................................34
Set Post Crank Seconds, Menu (13)..................................50
Set Pre Crank Seconds, Menu (13)....................................50
Set Relay 9 Volts DC, Menu (14).................................51, 52
Set RY7 Function, Menu (13).............................................49
Set Search Spacing, Menu ( 9) ..........................................46
Set Search Watts, Menu ( 9)..............................................46
Set Start Bulk Time, Menu (15) ..........................................51
Set Start Charge Time, Menu (18)......................................53
Set Temp Comp, Menu (10)...............................................47
Setup Menu ........................................................................44
Menu Map.......................................................................31
SineWave Communications Adapter (SWCA)..................127
SLT - Silent Mode.........................................................45, 81
Software Revision ................................................3, 5, 39, 93
Special Notices.....................................................................3
Specifications and Features .............................................117
Stacking Inverters (120/240 VAC) ................................71, 92
Stacking Port ......................................................................15
Start Charge Time.......................................53, 85, 86, 89, 90
Start Quiet Time, Menu ( 7)................................................43
Status LED..................................................................11, 127
SWCA .........................................................................29, 127
Remote Monitoring........................................................127
Remote Setup...............................................................127
Remote Troubleshooting ..............................................127
SWRC...............................................................................127
Contrast..........................................................................32
Controls And Indicators ..................................................32
Error LED Status Indicators
AC source wired to output..........................................42
External Error (stacked) .............................................42
Gen failed to start.................................................41, 79
Gen max run time error ..................................41, 78, 79
Gen speed error...................................................41, 79
Gen stopped due to V/F.......................................41, 79
Heatsink overtemp......................................................42
High Battery voltage...................................................41
Low Battery voltage....................................................40
Low Inverter voltage...................................................40
Over Current ..............................................................42
Transformer overtemp ................................................42
GEN Menu Button...........................................................34
LED Status Indicators.....................................................33
AC1 In Good (Green) .................................................33
AC2 In Good (Green) .................................................33
Bulk (Yellow)..............................................................33
Error (red).......................................................34, 40, 64
Float (Green)..............................................................34
Inverting (Yellow).......................................................33
Line Tie (Yellow)...................................................33, 86
Overcurrent (Red) ......................................................34
ON/OFF Menu Button.....................................................34
Remote Control...............................................................32
Reset to Factory Defaults Button....................................32
T
T240 Transformer.............................................................129
Technical Information .........................................................95
TFB, Fuse Block.................................................................22
Time of Day Metering ...................................................89, 90
Time of Day, Menu ( 6).......................................................43
Transfer Time ...................................................20, 68, 69, 80
Transformer Overtemp, Menu ( 5)......................................42
U
Universal Motors ...................................See Inductive Loads
Unpacking.............................................................................6
User Menu..........................................................................35
Menu Map.......................................................................30
Using Multiple Inverters......................................................92
Parallel Stacked Operation.............................................93
Utility Back-Up Applications ..........................................45, 81
Utility Back-Up Mode ..................................58, 89, 90, 91, 97
Utility Inter-Active Mode......................................................58
V
Ventilation...........................................................................18
Voltage Start Ready, Menu ( 2)..........................................38
W
Warning Label ....................................................................21
Warranty ...........................................................................128
Not Covered..............................................................17, 23
Shipping Address.........................................................134
Warranty Registration And Repair ................................133
Well Pumps ...........................................See Inductive Loads
Inverter Surge .............................See Locked Rotor Amps
Wiring
AC Terminal Block..........................................................19
AC Wiring .......................................................................18
Installation Guidelines.................................................20
Control
Fusing.................................................................73, 128
DC Wiring .......................................................................21
DC Disconnect...........................................................22
DC Overcurrent Protection .........................................22

Trace Engineering PS Series Specifications

General

Brand	Trace Engineering
Model	PS Series
Category	Inverter
Language	English