Trace Engineering PS Series User Manual

MENU SYSTEM
Page
30
Copyright  Trace Engineering Company, Inc.
5916 - 195th Street N.E.
Arlington, WA 98223
Telephone: 360/435-8826
Fax: 360/435-2229
www.traceengineering.com
PS Series Inverter/Charger
Part No. 3597
Rev. D: November 23, 1999
USER MENU MAP
Menu Heading The values shown are the factory default values for
12 VDC - 120 VAC/60HZ models.
Menu Item
Setpoint
See the USER and SETUP menu item descriptions
and default values for other models.
Information
Inverter Mode
1
Generator Mode
2
Trace
Engineering 3
Meters
4
Error Causes
5
Time of Day
00:00:00 6
Set Inverter
OFF SRCH ON CHG
Set Generator
OFF AUTO ON EQ
Press reset now
for defaults
Inverter/charger
amps AC 00
Low Battery
voltage NO
Set Clock hour
00:00:00
CHG avail. Only
in FLT mode.
Gen failed to
start NO
Revision 5.0
PS AE
Input
amps AC 00
Low inverter
voltage NO
Set Clock minute
00:00:00
Press setpoint
button to move
Gen stopped due
to V/F NO
5916 195th St NE
Arlington, WA
Load
amps AC 00
Low AC input
voltage NO
Set Clock second
00
cursor. Move
cursor to
Gen max run time
error NO
98223 USA Battery actual
volts DC 12.6
High Battery
voltage NO
Inverter OFF to
ResetOverCurrent
Gen speed error
NO
Ph 360-435-8826
Fax 360-435-2229
Battery TempComp
volts DC 12.6
High AC input
voltage NO
Load Amp Start
ready NO
Inverter
volts AC 00
Gen failed to
start NO
Voltage Start
ready NO
Grid (AC1)
volts AC 00
Gen stopped due
to V/F NO
Generator Timer
7
Exercise Start
ready NO
Generator (AC2)
volts AC 00
Gen max run time
error
NO
Start Quiet
time h:m 08:00
Move cursor to
GEN OFF to reset
Read Frequency
Hertz 60
Gen speed error
NO
End Quiet
time h:m 08:00
generator error. Read Bulk/EQ
timer h:m 00:00
Over Current
NO
Gen doesn’t run
during quiet
If no start in 5
trys then error.
AC1 & AC2 volts
valid only when
Transformer
overtemp NO
time unless batt
Volts is less.
If Gen runs for
more than max
inverter synced
to that input.
Heatsink
overtemp NO
than LBCO volts
for 30 seconds
run time then
error.
Batt volt actual
is used for
AC source wired
to output NO
or load > load
start amps.
Under/Over speed
Will cause a
LBCO,HBCO,LBX,
LBCI,sell volts,
External error
(stacked)
NO
To defeat timers
set start = end.
Sync error in 10
minutes
and gen starting High/Low ACinput
voltage error
If exercise days
set to 1 then
Batt volt temp
comp is used for
Detects single
cycle problems
gen will always
start @ endquiet
float, bulk, eq &
aux relays
with AC source
during charge or
Sell or passthru
Reset in 3 min.
END USER MENU
8
MENU HEADINGS
MENU ITEMS
Push buttons on
SWRC

Trace Engineering PS Series Specifications

General

Brand	Trace Engineering
Model	PS Series
Category	Inverter
Language	English