8-06 Reset Control Timeout
Option: Function:
This parameter is active only when the choice
Hold set-up
[0] has been
selected in par.8-05
End-of-Timeout Function .
[0] * Do not reset Retains the set-up specified in par.8-04
Control Timeout Function, [Select
setup 1-4] following a control time-out.
[1] Do reset Returns the frequency converter to the original set-up following a control
word time-out. When the value is set to
Do reset
[1], the frequency con-
verter performs the reset and then immediately reverts to the
Do not
reset
[0] setting.
8-07 Diagnosis Trigger
Option: Function:
This parameter has no function for LonWorks.
[0] * Disable
[1] Trigger on alarms
[2] Trigger alarm/warn.
8-1* Ctrl. Word Settings
Parameters for configuring the option control word profile.
8-10 Control Profile
Option: Function:
Select the interpretation of the control and status words corresponding
to the installed fieldbus. Only the selections valid for the fieldbus instal-
led in slot A will be visible in the keypad display.
[0] * FC profile
[1] PROFIdrive profile
[5] ODVA
[7] CANopen DSP 402
8-13 Configurable Status Word STW
Option: Function:
This parameter enables configuration of bits 12 – 15 in the status word.
[0] No function
[1] * Profile Default Function corresponds to the profile default selected in par.8-10
Control
Profile.
[2] Alarm 68 Only Only set in case of an Alarm 68.
[3] Trip excl Alarm 68 Set in case of a trip, except if the trip is executed by an Alarm 68.
[16] T37 DI status The bit indicates the status of terminal 37.
“0” indicates T37 is low (safe stop)
“1” indicates T37 is high (normal)
Parameter Description
TR200 Programming Guide 127
To Next Page
Loading...
