8-81 Bus Error Count
Range: Function:
0 N/A* [0 - 0 N/A] This parameter shows the number of telegrams with faults (e.g. CRC
fault), detected on the bus.
8-82 Slave Messages Rcvd
Range: Function:
0 N/A* [0 - 0 N/A] This parameter shows the number of valid telegrams addressed to the
slave, sent by the frequency converter.
8-83 Slave Error Count
Range: Function:
0 N/A* [0 - 0 N/A] This parameter shows the number of error telegrams, which could not
be executed by the frequency converter.
8-84 Slave Messages Sent
Range: Function:
0 N/A* [0 - 0 N/A]
8-85 Slave Timeout Errors
Range: Function:
0 N/A* [0 - 0 N/A]
8-9* Bus Jog
Parameters for configuring the Bus Jog.
8-90 Bus Jog 1 Speed
Range: Function:
100
RPM*
[0 - par. 4-13 RPM] Enter the jog speed. This is a fixed jog speed activated via the serial port
or fieldbus option.
8-91 Bus Jog 2 Speed
Range: Function:
200
RPM*
[0 - par. 4-13 RPM] Enter the jog speed. This is a fixed jog speed activated via the serial port
or fieldbus option.
8-94 Bus Feedback 1
Range: Function:
0 N/A* [-200 - 200 N/A] Write a feedback to this parameter via the serial communication port or
fieldbus option. This parameter must be selected in par.20-00
Feedback
1 Source, par.20-03 Feedback 2 Source or par.20-06 Feedback 3 Source
as a feedback source.
8-95 Bus Feedback 2
Range: Function:
0 N/A* [-200 - 200 N/A] See par.8-94
Bus Feedback 1 for further details.
8-96 Bus Feedback 3
Range: Function:
0 N/A* [-200 - 200 N/A] See par.8-94
Bus Feedback 1 for further details.
Parameter Description
TR200 Programming Guide 133
To Next Page
Loading...
