Trane TR200 Series - Main Menu Mode and Parameter Selection

Q3-4 Application Settings
Q3-40 Fan Functions Q3-41 Pump Functions Q3-42 Compressor Functions
par.22-60 Broken Belt Function par.22-22 Low Speed Detection par.1-03 Torque Characteristics
par.22-61 Broken Belt Torque par.22-23 No-Flow Function par.1-71 Start Delay
par.22-62 Broken Belt Delay par.22-24 No-Flow Delay par.22-75 Short Cycle Protection
par.4-64 Semi-Auto Bypass Set-
up
par.22-40 Minimum Run Time par.22-76 Interval between Starts
par.1-03 Torque Characteristics par.22-41 Minimum Sleep Time par.22-77 Minimum Run Time
par.22-22 Low Speed Detection par.22-42 Wake-up Speed [RPM] par.5-01 Terminal 27 Mode
par.22-23 No-Flow Function par.22-43 Wake-up Speed [Hz] par.5-02 Terminal 29 Mode
par.22-24 No-Flow Delay par.22-44 Wake-up Ref./FB Differ-
ence
Par.5-12 Terminal 27 Digital Input
par.22-40 Minimum Run Time par.22-45 Setpoint Boost par.5-13 Terminal 29 Digital Input
par.22-41 Minimum Sleep Time par.22-46 Maximum Boost Time par.5-40 Function Relay
par.22-42 Wake-up Speed [RPM] par.1-73 Flying Start
par.22-43 Wake-up Speed [Hz] par.1-86 Trip Speed Low [RPM]
par.22-44 Wake-up Ref./FB Differ-
ence
par.1-03 Torque Characteristics par.1-87 Trip Speed Low [Hz]
par.22-45 Setpoint Boost par.1-73 Flying Start
par.22-46 Maximum Boost Time
par.2-10 Brake Function
Par.2-16 AC brake Max. Current
par.2-17 Over-voltage Control
par.1-73 Flying Start
par.1-71 Start Delay
par.1-80 Function at Stop
par.2-00 DC Hold/Preheat Current
par.4-10 Motor Speed Direction
How to Program
34 TR200 Programming Guide