Trane TR200 Series - Page 34

Q3-3 Closed Loop Settings
Q3-32 Multi Zone / Adv
par.1-00 Configuration Mode
par.3-15 Reference 1 Source
par.3-16
Reference 2 Source
par.20-00 Feedback 1 Source
par.20-01
Feedback 1 Conversion
par.20-02 Feedback 1 Source Unit
par.20-03
Feedback 2 Source
par.20-04 Feedback 2 Conversion
par.20-05
Feedback 2 Source Unit
par.20-06 Feedback 3 Source
par.20-07
Feedback 3 Conversion
par.20-08 Feedback 3 Source Unit
Par.20-12
Reference/Feedback Unit
par.20-13 Minimum Reference/Feedb.
par.20-14
Maximum Reference/Feedb.
par.6-10 Terminal 53 Low Voltage
par.6-11
Terminal 53 High Voltage
par.6-12 Terminal 53 Low Current
par.6-13
Terminal 53 High Current
par.6-14 Terminal 53 Low Ref./Feedb. Value
par.6-15
Terminal 53 High Ref./Feedb. Value
par.6-16 Terminal 53 Filter Time Constant
par.6-17
Terminal 53 Live Zero
par.6-20 Terminal 54 Low Voltage
par.6-21
Terminal 54 High Voltage
par.6-22 Terminal 54 Low Current
par.6-23
Terminal 54 High Current
par.6-24 Terminal 54 Low Ref./Feedb. Value
par.6-25
Terminal 54 High Ref./Feedb. Value
par.6-26 Terminal 54 Filter Time Constant
par.6-27
Terminal 54 Live Zero
par.6-00 Live Zero Timeout Time
par.6-01
Live Zero Timeout Function
par.4-56 Warning Feedback Low
par.4-57
Warning Feedback High
par.20-20 Feedback Function
par.20-21
Setpoint 1
par.20-22 Setpoint 2
par.20-81
PID Normal/ Inverse Control
par.20-82 PID Start Speed [RPM]
par.20-83
PID Start Speed [Hz]
par.20-93 PID Proportional Gain
par.20-94
PID Integral Time
par.20-70 Closed Loop Type
par.20-71
PID Performance
par.20-72 PID Output Change
par.20-73
Minimum Feedback Level
par.20-74 Maximum Feedback Level
par.20-79
PID Autotuning
How to Program
TR200 Programming Guide 33