Trane TR200 Series - Page 33

Q3-3 Closed Loop Settings
Q3-30 Single Zone Int. Set Point Q3-31 Single Zone Ext. Set Point
par.1-00 Configuration Mode par.1-00 Configuration Mode
Par.20-12 Reference/Feedback Unit Par.20-12 Reference/Feedback Unit
par.20-13 Minimum Reference/Feedb. par.20-13 Minimum Reference/Feedb.
par.20-14 Maximum Reference/Feedb. par.20-14 Maximum Reference/Feedb.
par.6-22 Terminal 54 Low Current par.6-10 Terminal 53 Low Voltage
par.6-24 Terminal 54 Low Ref./Feedb. Value par.6-11 Terminal 53 High Voltage
par.6-25 Terminal 54 High Ref./Feedb. Value par.6-12 Terminal 53 Low Current
par.6-26 Terminal 54 Filter Time Constant par.6-13 Terminal 53 High Current
par.6-27 Terminal 54 Live Zero par.6-14 Terminal 53 Low Ref./Feedb. Value
par.6-00 Live Zero Timeout Time par.6-15 Terminal 53 High Ref./Feedb. Value
par.6-01 Live Zero Timeout Function par.6-22 Terminal 54 Low Current
par.20-21 Setpoint 1 par.6-24 Terminal 54 Low Ref./Feedb. Value
par.20-81 PID Normal/ Inverse Control par.6-25 Terminal 54 High Ref./Feedb. Value
par.20-82 PID Start Speed [RPM] par.6-26 Terminal 54 Filter Time Constant
par.20-83 PID Start Speed [Hz] par.6-27 Terminal 54 Live Zero
par.20-93 PID Proportional Gain par.6-00 Live Zero Timeout Time
par.20-94 PID Integral Time par.6-01 Live Zero Timeout Function
par.20-70 Closed Loop Type par.20-81 PID Normal/ Inverse Control
par.20-71 PID Performance par.20-82 PID Start Speed [RPM]
par.20-72 PID Output Change par.20-83 PID Start Speed [Hz]
par.20-73 Minimum Feedback Level par.20-93 PID Proportional Gain
par.20-74 Maximum Feedback Level par.20-94 PID Integral Time
par.20-79 PID Autotuning par.20-70 Closed Loop Type
par.20-71 PID Performance
par.20-72 PID Output Change
par.20-73 Minimum Feedback Level
par.20-74 Maximum Feedback Level
par.20-79 PID Autotuning
How to Program
32 TR200 Programming Guide