Trane Tracer AdaptiView Operation Guide

40 Tracer AdaptiView Display Operations Guide • CTV-SVU01B-EN
Equipment Settings
Changing the Setpoint Source
There are three ways to access the Setpoint Source screen. To change the setpoint
source, follow one of these procedures:
Changing the setpoint source using the Setpoint Source button in the chiller
status area
1. Touch t h e Setpoint Source button in the chiller status area (Figure 1, p. 7).
The Setpoint Source screen appears (Figure 22).
2. Touch the appropriate source button on the Setpoint Source screen.
3. Touch Save to complete the change.
Note: The change applies to all arbitrated setpoints.
Changing the setpoint source from the Setpoint Source button on the Chiller
Settings screen
1. Touch t he Settings button in the main menu area (Figure 1, p. 7). The Settings screen
appears.
2. From the Settings screen, touch the Chiller Settings button. The Chiller Settings
screen appears.
Figure 22. Setpoint Source screen

Trane Tracer AdaptiView Specifications

General

Brand	Trane
Model	Tracer AdaptiView
Category	Monitor
Language	English