TransAct Epic 430 - The TEST Button

Specifications and Requirements
Page 12 43-06955 - Rev Q
 4 MB minimum flash memory and 8 MB RAM
 Ithaca command set emulation
 Power: 24 VDC, 3 amps max.
 Power Connector: 4 pin Molex
 Paper Out, Paper Cover-Open, Top-Of-Form, Anti-Jam, Transport Ticket
Taken and Head Temperature sensors
 ON/OFF Switch located in rear of electronics base.
 Recessed cable access with easy to use cable strain reliefs.
 Power and error LED(s)
 Paper feed button
 Easy paper loading
 Portrait or landscape printing under Windows
 Internal counters to track number of hours on, cuts completed, lines fed,
and error conditions
 Capable of handling a 100 mm. (4.0 inch) diameter, 60 or 80mm. wide
paper roll
 Compliant with RoHS (Restriction on Hazardous Substances)
Optional Features
The following options are available:
 Variable length presenter, capable of handling from 63.5 to 254 mm. (2.5 -
10 inches) length tickets
 Paper Low sensor
 Custom emulations (Epson, Custom)
 Universal power supply (100-240 VAC, 47-63 Hz)
 Bezel assembly, with LEDs (translucent blue)
 Remote printer mounting kit
 Unified Model (base mounted on printer mechanism as shown Figure 1)