Configuring Your Epic 430
TM
Printer
43-06955 - Rev Q Page 33
Configuration Mode Overview
There are two ways to configure the Epic 430
TM
printer: the first is to use the
manual configuration sequence by using the TEST and FEED buttons, and the
second is to use TransAct’s remote configuration software. TransAct
Technologies offers the use of a remote CONFIG program as a fast, easy way
for system integrators to configure or reconfigure your Epic 430
TM
printer. To
obtain more information, or the latest version of the CONFIG program, call
TransAct’s Sales Department or Technical Support.
Most Frequent Configuration Incompatibilities
Emulation
RS-232 Serial Interface (baud rate)
How to Change Configuration Settings
Entering into Configuration Mode
1) Press the TEST button for approximately 4 seconds.
2) Select configuration mode using the FEED button.
Press and hold the Feed button to cycle through options.
Press and release the FEED button to select and option.
Power cycle to exit without changing.
Press the TEST button to save and exit.
3) Follow the printed instructions.
After you enter Configuration Mode, the printer will print the current
configuration, the current totals and the error logs, if any. Save this printout as
a guide to changing the configuration. It’s also useful in case you wish to
return the printer to the previous configuration.
Each emulation may have different configurable features. If you are changing
the emulation, note that the printout that was printed at the beginning of the
configuration process may be incorrect for the new emulation, and the
configurable features may be different. If you are using this printout as a
configuration guide, and you are changing the emulation, you may wish to
save the new emulation and then re-enter Configuration Mode to change other
options. This will print all the available features for the new emulation.
To Next Page
Loading...
