15
Automatic Callback
Description: When dialing another station that is busy, you may
activate an automatic callback. When the busy station
becomes free, your telephone set will ring. When you
answer the callback, the other station’s telephone will
ring and you will be connected.
To initiate a Callback:
1. Dial desired party and hear busy tone
2. Press [MSG]. Your telephone set will return to an idle condition.
To respond to a Callback:
1. If you are on a conversation and a callback has been left on your
telephone and you have an LCD display it will indicate in the lower
portion of the LCD: MSG ST:XX Also, your Message key will
flash. This tells you who is leaving the callback message.
Automatic Line Access
Description: Automatic Line Access allows a station to gain access
to a telephone line without pressing a specific CO
line button. It is also known as Dial 9 access.
1. Dial [9].
2. Outside CO line dial tone will be returned from the first available
CO line in your Dial 9 group. If no outside lines in your group are
available, you will hear a Busy signal.
Note: In some systems, you must dial [0] instead of [9] depending
on the country where you are located. Please check with
your system administrator for the applicable access code.
To Next Page
Loading...
