57
Volume Control
Description: The volume of the Ringer, Speaker, and Handset may
be programmed for each digital station. The volume
settings may also be changed for individual calls
without affecting the programmed levels.
Types: 1: Ring Volume
2: Speaker Volume
3: Handset Volume
4: Increase Ring Level Gradually
5: Ring Frequency
6: Microphone Level
7: Camp On Tone Volume Level
Permanent Programming:
1. While your station is idle, press [PRG], [6].
2. If your station is equipped with LCD, the display will show:
Set: 1:Ring 2:Spk
3:Handset More:#
3. Select the item that you want to program, (1, 2, or 3) or press the #
key for more options. (See types above)
4. Press [VOL↑
↑↑
↑] to increase the volume or press [VOL↓
↓↓
↓] to decrease.
5. Press [SAVE] to save the programming and exit to idle status.
Note: Each setting has eight discrete levels. LCD sets will show the
level number in the lower right corner of the LCD display. As
well you will hear an audible indication to allow you to selct the
most desireble level. It is suggested to leave the microphone
level at default.
Temporary Volume Adjustment:
1. While you are using your handset, your speaker, or your telephone
is ringing, you may:
2. Press [VOL↑
↑↑
↑] to increase the volume or press [VOL↓
↓↓
↓] on the
device (handset, speaker, ringer) that is operational.
3. If you are using your handset or speaker, the levels will revert to
permanent programming as soon as you hang up or turn off the
speaker. Ringing volume will revert to permanent programming on
the next call.
To Next Page
Loading...