Issue 1.3 September 2007
26
Check In - Check Out (Operator Function)
Description: Check In - Check Out allow an operator station to
change the dialing restriction of a telephone. This is
commonly used in Hotel applications where there is a
need to “turn off” dialing capabilies of individual room
telephones. This function is only available to system
operators.
Note: The use of Check In - Check Out requires that function keys
are programmed on the telephone set.
Check In:
1. Press [Hotel] and the digit 1.
2. Dial the room number to be unrestricted and desired toll class.
3. Press [SAVE].
Check Out:
1. Press [Hotel] and the digit 2.
2. Dial the room number to be restricted.
3. Press [SAVE].
1. You will hear a double ring on the telephone speaker indicating a
camped caller. If your set is LCD equipped, the display will show
the source of the party that is camped on, (i.e., LN 1, Local, etc.).
2. To answer the camp on you may:
3a. Finish the call that you are on and hang up. The camped-on call
will ring your telephone set. You may answer normally.
OR
3b. You may place your existing call on HOLD and Hang Up. The
camped on call will ring your telephone set. You may answer
normally.
Note: The volume level of the camp on tone may be adjusted to your
desired setting.
Camp-On-Call Waiting
(Continued)
To Next Page
Loading...