Issue 1.3 September 2007
54
3. Enter the storage location by dialing through for numeric or by
pressing button 1 through 10.
4. If you want your call to go out on a specific line, press the [MIC/
AT] and enter the line number. Press [MIC/AT] again and enter
the desired telephone number. If you want the call to go out on
any available line, just enter the desired telephone number and
press save.
The LCD Display will show the type of Speed Dial you are
storing by either Spd:Dxx if a DSS button (xx is the button
number selected from 01-10) or Spd:Nxx if a numeric entry (xx
is the keypad number 00-09).
If you selected a CO line, the display will show TK:xx (xx= the
CO line that you selected 8xx) or if the Dial 9 group, TK:00.
5. Enter the actual telephone number that you want to store,
(up to 30 digits.
6. Press [SAVE].
Note: Personal Speed Dial is subject to any toll control assigned
to your station.
Personal Speed Dialing
(Continued)
One Touch Speed Dialing
Description: After programming a personal speed dial number on
your telephone set, you may automatically dial this
number simply by pressing the key, provided that the
key is programmed as Fun:00 in system programming.
In this case the key is dedicated for this function and it
is not necessary to press the speed dial button
followed by the key to make the call.
To Next Page
Loading...
