23
CO Line Callback (Line queuing)
Description: When you attempt to access an outside CO line and it
is busy, you may choose to be notified when it
becomes available.
1. Dial [9] or press a CO line button. The line is busy.
2. Press [MSG]. Hang up (if you were using the [SPK], your
telephone will become idle as soon as you press the [MSG]
button).
3. When the line or line group that you attempted to access
becomes free, your telephone will ring.
4. When you answer, you will be connected to outside CO line dial
tone.
5. You may dial your call normally.
Note: If you do not answer your telephone in Step 4 above, the
system will automatically cancel the callback feature after
approximately 25 seconds.
Calling the Doorphone
Description: The GDS Digital Telephone system is equipped to
support multiple doorphones. If your system is
equipped with a doorphone, you may place a call to
it.
1. Dial the station number to call the doorphone or Press the
[DSS] key.
2. You will be connected to the doorphone dialed if it is not already
connected to another station. While you are connected to the
doorphone, you may press [0] to activate a door strike release. If
there is not a door strike relay programmed for the system, this
will have no effect on the doorphone. If you have a door phone
key programmed on your telephone, you may activate the strike
release relay by pressing it, instead of [0].
Note: You cannot place a doorphone on Hold, conference a
doorphone, or transfer a call to a doorphone.
To Next Page
Loading...