Issue 1.3 September 2007
16
Automatic Last Number Redial
Description: Automatic Last Number Redial allows you to
repeatedly dial the last external number dialed from
your telephone. This feature is most commonly used
when calling a telephone number that is continously
busy.
1. Place an outside CO line call.
2. Hang Up.
3. Press [SPD], [REDIAL].
4. The system will access a CO line and dial the number that was
previously dialed from your telephone.
5. The system will remain off hook for a pre-programmed period. If
you do not lift the handset, the telephone will automatically hang
up.
6. The system will periodically repeat steps 4 and 5 until either the
number of attempts has been satisfied (as per system
programming) or until you lift the handset while an attempt is in
progress.
Description: Automatic Redial allows you to save a telephone
number for use at a later time. This feature is in
addition to Last Number Redial.
1. You have dialed an outside call. The number does not answer or
is busy.
2. Press [SAVE].
3. The lower portion of the LCD
(on display telephones) will display: Auto Save
4. You may hang up.
5. You may make other calls if you wish.
6. While your telephone is idle, press [SAVE].
7. The telephone will access an available line, turn on your speaker
and redial the saved number.
8. If you take no action, the system will monitor the call for a
programmable period of time and then disconnect the call and
return your telephone to idle.
9. The telephone set will periodically access a CO line and continue
to redial the saved number. Steps 7 and 8 will continue for a
programmed number of times or until you lift the handset while an
attempt is in progress.
Note: If you place another call while Auto Redial is active, your
telephone will wait until you have finished the call and resume
the Auto Redial mode.
Automatic Redial
To Next Page
Loading...