Issue 1.3 September 2007
24
Call Forwarding
Description: Call Forwarding allows you to re-route calls that
normally ring at your telephone set. The TDS 600
system supports five variants of Call forwarding;
Always Forward, Busy Forward, No Answer, Busy/No
Answer and External Call Forward.
If you are the Console Operator, you may forward other stations in
the system as well as your own.
For Console Operators:
1. Press [PRG], [FWD] .
2. LCD (if equipped) will show: Enter Sta Number
Enter the station number you want to forward
3. Press the number corresponding to the desired type of
forwarding. LCD (if equipped) will show: 1=All
2=Busy 3= BSY/No Answer 4= No Answer
4. Enter the station number where you want your calls forwarded.
5. If your station is equipped with a Call Forward button, it will flash
to indicate that call forwarding is in effect on your station.
Note: Stations with Call Forwarding buttons may deactivate Call
forwarding by pressing the button. Once programmed, the button
becomes a toggle, alternately enabling and disabling call forwarding.
It is only necessary to re-program Call Forwarding if you change the
type of forwarding or the forwarding destination.
Deactivating:
1. Repeat steps 1, 2, and 3 listed above for any programming.
2. Enter your own station number or forwarded station number.
3. Call forwarding is deactivated.
For Non Console Operators:
Follow the above procedure. You will not be prompted for the Station
Number.
To Next Page
Loading...