Model 3440 5–13
Taking Nomograph Measurements
When the Nomograph function is enabled, the gauge can be used
to take thin-layer overlay measurements. Press
¢ENTER/START² to begin the test. The gauge displays:
Depth: BS in
( Nomograph )
Time: xx s
After counting down to zero, the display is:
%Gmb= ####
W= ##
( Nomograph)
This test may be stored as any other test measurement. The
recall function and/or printout will show that the Nomograph
function was used.
NOTE
The
Nomograph
function should be disabled before
taking any measurements not requiring this function.
To Next Page
Loading...
