5–12
Enter the number of readings to be taken and averaged, then
press ¢ENTER/START². The gauge displays:
Readings: #
Time: # m
Place Rod to BS &
Press <START>
Prepare the site for measurement as described on page 4–22.
Position the gauge and press ¢ENTER/START². The gauge
displays:
Nomograph
Reading: 1
Depth: BS
Time: ## s
After counting down to zero, the gauge displays:
Reading: 1
WD= ### pcf
Move Gauge and
Press <START>
If more than one reading is to be taken, move the gauge to the
next location and press ¢ENTER/START². The gauge will repeat
the above sequence for each reading. When all the readings are
completed, the display will be:
Average of #
Redings
### pcf
Press <ENTER>
Press ¢ENTER/START² to continue. The gauge enables the
Nomograph function, displays a brief confirmation message, and
returns to the Setup menu.
To Next Page
Loading...
