● Do not use non-genuine spares like pads, discs,
tyres etc.
● Do not try to service HECU or open to separate parts.
● Do not disengage the ABS by removing the ABS
coupler.
● Do not use different toner ring.
● Do not insert any metallic parts near wheel speed
sensor.
● Do not test the ABS on road!!, but use ABS (it is
already tested).
Incase of ABS failure, the braking system will work like a
non ABS braking system and provides normal stopping
distance.
This motorcycle is equipped with ABS and tubeless
tyres. For repair or replacement please contact nearest
TVS Motor Company Distributor, Dealers / Authorised
Service Centers.
As a general riding practice it is advisable to apply more
front brake and less of rear brake.
Never open HECU on your own, it is a very sensitive part
of ABS and needs to be handled only by the trained
personnel. Contact your nearest TVS Motor Company
Distributor, Dealers / Authorised Service Centers.
Use of non-genuine brake pads, tyres, disc etc. leads to
poor braking performance and unsafe riding conditions
Note
Do not ride the vehicle in conditions like wheelie, stoppie,
on-stand engine revving in gear for chain lubrication and
during water wash etc... for more than three minutes as it
will result in ABS error and ABS warning lamp glowing
continuously. In such cases, just switch 'OFF' and switch
'ON' the ignition key once. ABS warning lamp may glow
continuously if any ABS error had occurred before.
This error gets cleared automatically and ABS warning
lamp goes 'OFF' after riding the vehicle above 10 km/h
speed. If the ABS warning lamp is still 'ON', then contact
the nearest TVS Motor Company Distributor, Dealers /
Authorised Service Center (applicable only for dual
channel ABS system).
Warning
06
ANTI-LOCK BRAKING SYSTEM
To Next Page
Loading...
Need help?
General
