SETTING THE VEHICLE IN MOTION
1. Press the clutch lever and engage first gear by
pressing the gearshift lever down.
2. Open the throttle slowly and simultaneously,
release the clutch lever gently and gradually. The
vehicle starts moving forward.
3. As the vehicle picks up speed, shift to the next
higher gear by closing the throttle, applying the
clutch and lifting the gear shift lever up.
4. Release the clutch lever and open the throttle
smoothly. Select the required gears in a similar
manner.
Using the transmission
The transmission is provided to keep the engine to run
smoothly in its normal operating speed range.
The gear ratios have been carefully chosen to meet
the characteristics of the engine.
The rider should always select the most suitable gear
to achieve the necessary speed and pulling power
smoothly.
STARTING THE ENGINE
As you turn the ignition switch to the ’ON’ position,
the instrument cluster and the warning lights will go
through the self-diagnostic cycle. During this phase,
make sure that all the warning lights on the cluster
comes on.
The following conditions must be verified before
starting the engine.
q The engine cut off switch is in ‘ ‘ position.
q The gear is in neutral.
q If gears are engaged, the clutch lever is pulled.
Press the start button without applying the throttle.
As soon as the engine starts, release the start button.
The engine will not start if the throttle is opened full.
Do not keep the engine in idling rpm for long and do
not open excessive throttle when the vehicle is
parked. It leads to overheating of engine and damage
to the internal components.
Caution
RIDING YOUR TVS APACHE RTR 200 Fi4V
58
To Next Page
Loading...
Need help?
General
